Page Comparison

...

• First verify that audittrail events has been collected . All audittrail events should be requested via the web interface.
  
  • The returned list should contain entries from all the different components expected to deliver audit trail information.
  Test the different filters
  
• Dates:
  
  • Filter on a valid date range
    
    • Only audit trail events from the date range should be present in the list of audit trail events.
  • Filter on an invalid date range (the start date being after the end date)
    
    • No change should happen to the list of events
  • Filter only on a start date
    
    • Only events from the start date and forward should be present in the event list
  • Filter only on a end date
    
    • Only event prior and up to the end date should be present in the event list
• Filter on a known fileID
  
  • Only events related to the specified fileID should be present in the event list.
• Filter on an unknown fileID
  
  • No events should be present in the event list
• Filter on a known component
  
  • Only events from the specified component should be present in the event list
• Filter on an unknown component
  
  • No events should be present in the event list
• Filter on a known actor
  
  • Only events related to the specified actor should be present in the event list
• Filter on an unknown actor
  
  • No events should be present in the event list
• Filter on the different action types
  
  • Only actions from the specified type should be present. "ALL" being the exception, as it should allow for any type.
• Filter a couple of collections and verify only audit trails for the selected collection is listed.
Change the number of listed event and verify the number of listed event changes accordinglyby expanding the Show collection schedule panel.
• Verify that new audit trails are collected:
  •  Put a new file.
  • Trigger a new retrieval of audit trails.
  • Verify that Last collected number of audits column of the Show collection schedule panel show a number of audit trails where collected from the relevant collection.
• Test the different filters: Set each filter to a given value and verify that the table filters correctly.

Audit trail preservation

This test is rather cumbersome, and should only be run in case of changes to the code affecting the audit trail preservation

...